How to Modify an existing connection in Windows Millenium Edition

1. From the Start menu, choose Settings.
2. Select Dial-Up Networking
3. Right-click on the tribcsp.com icon, and select Properties
4. Verify that the phone number listed matches your local access number.
5. Verify that the box labeled Use Area Code and Dialing Properties is unchecked.
6. Click on the Configure button.
7. Verify that the Maximum Speed is set no higher than 57600, and Only connect at this speed is unchecked.
8. Click OK.
9. Click on the Networking tab.
10. Check the box next to Enable Software Compression.
11. Uncheck the box next to Record a log file for this connection.
12. Uncheck the box next to NetBEUI.
13. Uncheck the box next to IPX/SPX Compatible.
14. Check the box next to TCP/IP.
15. Click on the TCP/IP Settings button.
16. Verify that Server assigned IP address is selected.
17. Verify that Server assigned name server addresses is selected.
18. Check the box next to Use IP header compression.
19. Check the box next to Use default gateway on remote network.
20. Click OK.
21. Click OK.
22. Close the Dial-Up Networking window.